Jury Report on 2017 Indoor Free Flight European Championships F1D for Seniors and Juniors
FAI Jury
Andras Ree |
HUN/TD> | President |
Wilhelm Kamp |
AUT |
Member |
Mihail Zanciu |
ROU |
Member |
Dates
Location
Information
There were two pre-contest bulletins with all necessary information. Hard copies of a final bulletin were distributed to all teams at the team managers meeting.
Accommodation
Participants were accommodated mainly at Hotel Roberto in Slanic and in other private pensions. Breakfasts and dinners were served at the hotel restaurant, the lunch at the flying site in the salt mine. Food and accommodation were good. Transportation to and from the salt mine was by vans provided by the mine through the tunnel in a 10 minutes long ride, because the escalator is still out of service because of safety reasons.
Flying site
The event was organized in the salt mine of Slanic-Prahova. Several FAI Cat 1 events took place in this salt mine, before in the Mihai, now in the Unirea mine hall: World Championships 1970, 1982, 1994, 1998, 2000, 2002, 2004, 2006, 2014, 2016 and European Championships 1991, 1997, 2015. The organizer succeeded to run these events according to the FAI/CIAM standards in spite of financial restrictions, with support by local authorities and a few sponsors. Therefore it deserves appreciation of all participants.
Flying site is positioned at an unusual location in the not operating part of the salt mine. There are two halls suitable for indoor competitions: one (Mihai) where indoor competitions usually were being held with a ceiling at 63,5 m height and is not used for visitors, and the deeper (200 m under the ground, called Unirea) arranged for tourist visits. This time a limited part of this lower level was used for the competition. The site was divided into flying area, preparation area, practicing area and restricted area (forbidden admittance). One table with chairs was provided for every competitor, place for the computerized data processing, a tent for model processing and a table and chairs for the jury.
Bottled water was available at the flying site every day. There was also a restaurant with good lunches. At this level of the mine the toilets are much better than that of in Mihai, with warm and cold water for washing hands, but located at five minutes walking distance!
The competition area was about 30 x 75 m and 54 m high, and allowed flying of up to 12 models at the same time. Seniors and juniors competed simultaneously without any problem. Timekeeping was without any problems or complaints. Illumination of this hall is much better than that of in the upper hall Mihai, formerly used for indoor competitions.
Participation
Contest organisation
The outer weather conditions are nearly insignificant here. Air temperature was about 11°C that is about constant throughout the year. The humidity varies with the seasons, the Winter time is the driest, now it was about 50%.
Model processing and rubber testing: Model processing was in a processing tent where scales and the necessary dimension limits were provided. The rubber weight was measured by a small electronic scale, but the traditional scale for measuring the model weight needs improvement.
Flying: Two rounds were flown on each of the three contest days with 3 hours round time and the lunch break in between. The Contest Director kept the contest well in hand providing efficient flying procedure. Timekeeping was fair and correct. The teams had a pair of timekeepers for a day, different for each day.
Briefing: One smooth and short team managers meeting was held in the evening of the practice day.
Data processing: Data processing was running on a computer located in the preparation area. It was equipped with a printer and a large monitor to follow the standings during the contest. This system was running by skilled operators. All necessary data were posted after each flight to the monitor.